The 10 most-cited articles in Japanese Journal of Radiological Technology, 2016

Measurement of the half-value layer (HVL) is a difficult task in computed tomography (CT) , because a nonrotating X-ray tube must be used. The purpose of this study is to develop a lead-covered case, which enables HVL measurements with a rotating CT X-ray tube. The lead-covered case was manufactured from acrylic and lead plates, which are 3 mm thick and have a slit. The slit-detector distance can be selected between 14 mm and 122 mm. HVL measurements were performed using a wireless X-ray output analyzer "Piranha." We used the following exposure conditions: tube voltages of 80, 100, and 120 kV; a tube current of 550 mA; and an exposure time of 1.0 s. The HVLs were measured by using the following two methods: (a) Nonrotating method-a conventional method that uses the nonrotating exposure mode. (b) Rotating method-a new method that uses the lead-covered case and the rotating exposure mode. As a result, when the slit-detector distance was 58 mm, the HVL values obtained by the nonrotating and rotating methods were 4.38 and 4.24 mmAl at 80 kV, 5.51 and 5.37 mmAl at 100 kV, 6.61 and 6.48…

The aim of this study is to analyze the maldistribution and the trends in the geographic distribution of radiological resources in secondary medical areas of Hokkaido. The distribution was measured by combining the Gini coefficient (GC), which is an indicator of inequality of distribution, and the Herfindahl-Hirschman index (HHI), which is mainly used to assess market concentration. Data concerning the distribution of radiological resources, such as CT, MRI, radiotherapy facilities (RTF), radiological technologists (RT), and medical doctors were obtained from official publications. CT was more equally distributed, and RTF was more inequality than other radiological resources in 2014. Radiological resources excluded CT were higher degree of concentration than population distribution, and it showed that they were located relatively more intensively in urban areas than in rural areas. During the period 1999-2014, the GC for CT, MRI, RTF, and RT decreased, while the HHI increased. These trends indicated increased equality of distribution of CT, MRI, RTF, and RT and the concentration in…

BACKGROUND AND PURPOSE: Recently, the number of patients with nonalcoholic fatty liver disease (NAFLD) has been increasing, and some of them progresses to cirrhosis and hepatocellular carcinoma. Dual energy CT allows the discrimination of substance using monochromatic image (MI), and steatosis exhibit specifically the CT value of each energy level. The purpose is to evaluate the fat quantification in the liver using spectral HU curve and CT value compare to a conventional image diagnosis. METHODS: Dual energy CT and liver biopsy were performed in 54 patients between October 2014 and April 2016. The CT value of 40 keV MI was measured by spectral HU curve setting 3 points ROI on the right and left liver. The CT value of 40 keV MI was compared with steatosis area and the NAFLD activity score (NAS). Additionally, steatosis area was compared with the conventional CT value scan and hepatorenal echo contrast value. RESULTS AND DISCUSSION: =0.135). This study suggests that the evaluation of the fat quantification in the liver using the spectral HU curve and CT value improved in comparison…

It is well-known that metal artifacts have a harmful effect on the image quality of computed tomography (CT) images. However, the physical property remains still unknown. In this study, we investigated the relationship between metal artifacts and tube currents using statistics of extremes. A commercially available phantom for measuring CT dose index 160 mm in diameter was prepared and a brass rod 13 mm in diameter was placed at the centerline of the phantom. This phantom was used as a target object to evaluate metal artifacts and was scanned using an area detector CT scanner with various tube currents under a constant tube voltage of 120 kV. Sixty parallel line segments with a length of 100 pixels were placed to cross metal artifacts on CT images and the largest difference between two adjacent CT values in each of 60 CT value profiles of these line segments was employed as a feature variable for measuring metal artifacts; these feature variables were analyzed on the basis of extreme value theory. The CT value variation induced by metal artifacts was statistically characterized by…

Anterolateral ligament (ALL) is one of the lateral structures in the knee that contributes to the internal rotational stability of tibia. ALL has been referred to in some recent reports to re-emphasize its importance. We visualized the ALL on 3D-MRI in 32 knees of 27 healthy volunteers (23 male knees, 4 female knees; mean age: 37 years). 3D-MRIs were performed using 1.5-T scanner [T(2) weighted image (WI), SPACE: Sampling Perfection with Application optimized Contrast using different flip angle Evolutions] in the knee extended positions. The visualization rate of the ALL, the mean angle to the lateral collateral ligament (LCL), and the width and the thickness of the ALL at the joint level were investigated. The visualization rate was 100%. The mean angle to the LCL was 10.6 degrees. The mean width and the mean thickness of the ALL were 6.4 mm and 1.0 mm, respectively. The ALL is a very thin ligament with a somewhat oblique course between the lateral femoral epicondyle and the mid-third area of lateral tibial condyle. Therefore, the slice thickness and the slice angle can easily…

To obtain patient entrance surface dose in X-ray photography, a calculation method based on measured exposure or air kerma radiated from X-ray tube is generally used. Two factors are necessary for this calculation: (1) exposure/air kerma to absorb dose conversion factor and (2) back-scatter factor (BSF) based on X-ray quality and on field size. These BSFs are commonly obtained by interpolation from existent data which were given for a water phantom whose entrance surface is flat. Since patient's surface in X-ray photograph is not flat, some error may occur when existent BSF is used in this calculation. In this article, BSF for water phantom with cylindrical surface and elliptic cylinder surface were calculated by means of the Monte Carlo simulation. And these BSFs were compared with BSF for flat surface phantom. As a result (1) radius of curvature of cylindrical phantom or horizontal axis of elliptic cylinder phantom is smaller, (2) half value layer of X-ray is larger, (3) field size is larger, difference of these BSF with that for flat surface phantom tends to be larger. Maximum…

In magnetic resonance imaging (MRI), when radiofrequency (RF) is irradiated to a subject with metallic implant, it can generate heat by RF irradiation. Recently 3 T MRI scanner has spread widely and imaging for any regions of whole body has been conducted. However specific absorption rate (SAR) of 3 T MRI becomes approximately four times as much as the 1.5 T, which can significantly affect the heat generation of metallic implants. So, we evaluated RF heating of artificial hip joints in different shapes and materials in 1.5 T and 3 T MRI. Three types of artificial hip joints made of stainless alloy, titanium alloy and cobalt chrome alloy were embedded in the human body-equivalent phantom respectively and their temperature change were measured for twenty minutes by 1.5 T and 3 T MRI. The maximum temperature rise was observed at the bottom head in all of three types of artificial hip joints, the rise being 12°C for stainless alloy, 11.9°C for titanium alloy and 6.1°C for cobalt chrome alloy in 1.5 T. The temperature rise depended on SAR and the increase of SAR had a good linear…

OBJECTIVES: The aim of this study was to evaluate the effectiveness of scatter correction in the portable chest radiography. METHODS: Digital radiographies were performed without anti-scatter grid (grid), with the scatter correction and with the grid ratio of 3 : 1 in this study. The scatter fraction and the detectability of low contrast signals were measured using the four acrylic phantoms of different thicknesses. The chest phantom radiographs were assessed subjectively, in random order, by six radiologic technologists. RESULTS: The scatter fraction was higher in the no-grid technique, and was lower for the grid technique. The detectability of low contrast signals did not significantly differ between the scatter correction and the grid technique (p>0.05). The area under the receiver operating characteristic curve for the grid technique was higher than that for the scatter correction technique (0.888 vs. 0.855), although no significant difference was found between the grid and the scatter correction technique (p> 0.05). The ability to detect the nasogastric tube was significantly…

PURPOSE: The aim of this study was to validate the reliability of dose calibrators for measuring the radioactivity of several radioisotopes in multi-institution. METHODS: We evaluated the measurement accuracy of dose calibrators using a commercially available source ((67) Ga, (99m) Tc, (123) I, (201) TL). Nine dose calibrators (five models) in seven institutions were performed in this study. Each source was measured at least 3 times a day over a period of 4 half-life. Linearity of concentration (%error value) and percent difference values (%diff measurement) between measured and estimated radioactivity were calculated to evaluate the measurement accuracy. In addition, difference among institutions (%diff institution) was evaluated by the error values between measured and reference institution values. RESULTS: Good linearity of concentration was found between measured and estimated radioactivity in (99m)Tc and (123)I. However, %error value was increased in (67)Ga and (201)TL (maximum 19.3%). %diff measurements were 1.9 ± 0.3% for (67)Ga, -0.9 ± 0.3% for (99m)Tc, 2.2 ± 0.4% for…